Tektronix TBS1000C Series User Manual

create new folder (USB drive), 140
delete files or folders, 141
disable Autoset button, 67
disable cursor button, 106
disable USB Device port, 147
enable HelpEverywhere, 29
erase oscilloscope memory, 145
examine waveform details (zoom), 119
find information on supported probes, 23
install language overlay, 19
install new firmware, 151
invert the input signal, 46
link cursors, 101
load a courseware file, 155
load factory settings, 77
load oscilloscope setups, 133
load waveform files, 134
move a waveform (vertical), 53
move both cursors at same time, 101
move cursors onto screen, 101
Multiply waveforms (math), 108
open reference waveforms, 118
perform a functional check, 24
power off the oscilloscope, 14
prevent electrostatic damage, 24
quickly set 1X, 10X attenuation, 50
recall oscilloscope setups, 133
recall waveform data, 134
recall waveform files, 134
remove a waveform from the screen, 79
rename files or folders, 143
restore default settings, 77
restore factory settings, 77
run courseware labs, 156
Run SPC, 32
save courseware lab results (report), 158
save oscilloscope setups, 128
save screen to a USB drive, 125
save waveform data, 126
select a measurement, example, 26
select automatic measurements, 87
select cursors, 101
select device for USB port, 148
select slope (edge trigger), 63
set acquisition mode, 71
set backlight intensity, 85
set bandwidth, 47
set channel deskew, 55
set DC offset on a signal, 52
set default save location (Change Folder), 139
set Edge trigger, 57
set FFT center position, 110
set FFT horizontal scale, 110
set FFT source wfm, 110
set FFT vertical units, 110
set FFT window type, 110
set Hi Res acquisition mode, 71
set input signal coupling, 45
set measure current (for voltage probe), 51
set measurement gating, 97
set Peak Detect acquisition mode, 71
set probe attenuation, 49
set probe type (voltage, current), 48
set pulse width trigger, 59
set record length, 74
set runt pulse trigger, 61
set Sample acquisition mode, 71
set Save File button, 129
set signal DC offset, 52
set slope (edge trigger), 57
set the date and time, 20
set the language, 15
set trigger coupling (edge trigger), 57
set trigger holdoff, 63
set trigger modes, 63
set trigger source, 57, 59, 61
set trigger when condition (pulse width), 59
set trigger when condition (runt pulse), 61
set vertical offset, 52
set vertical position, 53
set waveform decay time, 80
set waveform persistence, 80
show a snapshot of all measurements, 89
show FFT source wfm, 110
show help on menu items, 29
show measurements, 87
Index
184 TBS1000C Series Oscilloscopes User Manual

Tektronix TBS1000C Series Specifications

General

Brand	Tektronix
Model	TBS1000C Series
Category	Test Equipment
Language	English