TESTO Saveris - Dropping Compression; Determining Largest Reading; Determining the Smallest Reading; Analyzing Alarms

6 Using the product
114 0970 4020 en 01 testo AG
6.5.2.5. Dropping compression
> Click on Edit | Tools | Drop compression.
- The table is shown again in its uncompressed form.
Pos: 153 /TD/Produ kt verwenden/testo Sa veris/05b Tabellen a nalysieren/07 größter Messwert @ 0\mod_1188996 639859_79.doc @ 3625
6.5.2.6. Determining largest reading
> In the Edit | Find | Maximum menu click on the curve for
which the largest reading should be determined.
- The largest reading is shown marked in the table.
Pos: 154 /TD/Produ kt verwenden/testo Sa veris/05b Tabellen a nalysieren/08 Klein ster Messwert @ 0\mod_118 8996639562_79.doc @ 3615
6.5.2.7. Determining the smallest reading
> In the Edit | Find | Minimum menu click on the curve for
which the smallest reading should be determined.
- The smallest reading is shown marked in the table.
Pos: 155 /TD/Produ kt verwenden/testo Sa veris/06c Alarme ana lysieren/00 Alarme ana lysieren @ 0\mod_1189079 097312_79.doc @ 3954
6.6. Analyzing alarms
If system or probe alarms were triggered by the Saveris base,
you can check the alarms and subsequently confirm
(acknowledge) them.
The
symbol in the display range of the task bar also
you that an alarm was issued by the Saveris base, even
with the software closed. If you move to the symbol with
the mouse information is shown regarding the alarm.
If an alarm is not triggered, this is shown by the
symbol.
Pos: 156 /TD/Produ kt verwenden/testo Sa veris/06c Alarme ana lysieren/01 Alarme pr üfen @ 0\mod_1189079390359_ 79.doc @ 3963
6.6.1. Checking alarms
> In the diagram or table view under Start | View mark the
Alarms option.
- The alarms received are shown in the
Overview below the
diagram or the table.
>
Designation Explanation