5 First steps
58 0970 4020 en 01 testo AG
3. Hold down the connect key on the rear of the router until
the LED at the router begins to flash orange.
- The LED
at the router briefly turns green if this was
detected by the Saveris base.
The LED at the Saveris base
briefly flashes green and a
prompt appears in the display of the base for the connection
of more probes or routers.
Multiple routers cannot be connected at the Saveris
base simultaneously. Multiple routers can only be
connected one after the other.
4. At the Saveris base, press the
•
[Esc] key if no more components are to be connected.
- A note on the required performance of the startup
assistant is shown on the display for about ten seconds.
Then the Saveris base changes to the
Info System
menu in which the number of connected components
is now shown.
• Press [Enter] if further components are to be connected;
see previous step.
Pos: 73 /TD/Erst e Schritte/testo Saver is/Hardware erwei tern/01 Router einbinden/ 03 Fühler zuweisen @ 1\ mod_1197548250906_79. doc @ 6284
5.12.1.4. Assigning probes
To assign a probe to a router, both must be connected
in the Saveris base.
To Next Page
Loading...
