TESTO Saveris - 7 Maintaining the Product; Replacement of Components; Deleting Components

7 Maintaining the product
130 0970 4020 en 01 testo AG
Pos: 172 /TD/Übersc hriften/7. Produk t instand halten @ 0\mod_11 73789831362_79.doc @ 397
7 Maintaining the product
Pos: 173 /TD/Produ kt instand halten/te sto Saveris/00 Ersat z von Komponenten @ 0\mod_1188 476464890_79.doc @ 2909
7.1. Replacement of components
You can shut down a component – probe, converter or router –
at any time because this is temporarily not in use or to replace it
with a new component, for example, in the event of a defect.
In the event of a replacement of the Saveris base, you
must reinstall the software and set up the entire
measurement system again.
Remember to save the existing measurement data
before reinstalling the software.
Pos: 174 /TD/Produ kt instand halten/te sto Saveris/01 Komponen ten entfernen @ 0\mod_1 193737448921_79.doc @ 5643
7.1.1. Deleting components
1. Under Start | All Programs | Testo click on Saveris
Startup Assistant
.
- The welcome dialogue of the startup assistant is shown.
2. Click on [Continue >].
- The
System status dialogue with the General tab is shown.