6 Using the product
0970 4020 en 01 117
5. Mark the entry of the alarm that should be acknowledged.
6. If needed, enter Comments on the alarm in the field of the
same name and confirm the alarm with
[OK].
- The symbol shows that the alarm was confirmed and the
comments are carried over in the alarm list in the display
range.
The confirmation of the alarm is transmitted to the Saveris
base. As soon as the confirmation is received in the Saveris
base, the alarm relay stops flashing and the alarm is
deleted.
Pos: 158 /TD/Produ kt verwenden/testo Sa veris/07 Beric hte/00 Berichte erstellen @ 0\mod_1190280535671_ 79.doc @ 5032
6.7. Creating evaluations
You can print out series of measurements or have reports on
the data automatically created by the software in definable
intervals.
Pos: 159 /TD/Produ kt verwenden/testo Sa veris/07 Beric hte/01 Bericht drucken @ 0\ mod_1189522120546_79.doc @ 4294
6.7.1. Printing measurement data
Measurement data can be printed in diagram or table form.
1. Select the day or time period in the calendar for which the
report should be created.
- The data for the day or the time period are shown as a
diagram or table, depending on the setting.
> In the
Start | View menu, select the
•
Diagram command if the table view is activated but the
diagram view should be printed.
• Table command if the diagram view is activated but the
table view should be printed.