6 Using the product
0970 4020 en 01 121
6.9. System settings
In this menu, determine the settings for the Saveris base, the
radio probes and – if installed in the measuring system – the
Ethernet probes, router and converter.
> Click on
System in the navigation area.
- The following entries are shown in the tree structure in the
data range:
•
Base with the general settings of the Saveris base and
the SMS module (if present) as well as the operating
data of the probes.
•
Radio probe with the settings for the radio probes
connected to the Saveris base.
•
Ethernet probe with the settings for the Ethernet probes
attached to the Saveris base.
•
Router with the settings for the routers connected to the
Saveris base.
• Converter with the settings for the converters connected
to the Saveris base.
Pos: 163 /TD/Produ kt verwenden/testo Sa veris/09 Einstellu ngen System/01 Allgem ein @ 0\mod_118899790504 6_79.doc @ 3801
6.9.1. General settings for the Saveris base
Using this menu item you can, for example, synchronize the
date and time of the Saveris base with the values from the
computer or change the IP address of the Saveris base.
1. Open the
Base entry.
- The submenu items
General, SMS module and Operating
data
are shown under the entry.
2. Click on
General to open the basic settings for the Saveris
base.
- The settings of the Saveris base are shown in the display
range.
To Next Page
Loading...
Need help?
General
