TESTO Saveris User Manual

5 First steps
0970 4020 en 01 39
3. Hold down the connect key on the rear of the probe until
the LED at the probe begins to flash orange.
- The LED
at the probe briefly turns green if this was
detected by the Saveris base.
The LED at the Saveris base
briefly flashes green and a
prompt appears in the display of the base for the connection
of more probes or routers.
Multiple probes cannot be connected at the Saveris
base simultaneously. Multiple probes can only be
connected one after the other.
4. At the Saveris base, press the
•
[Esc] key if no more components are to be connected.
- A note on the required performance of the startup
assistant is shown on the display for about ten seconds.
Then the Saveris base changes to the
Info System
menu in which the number of connected components
is now shown.
• Press
[Enter] if further components are to be connected;
see previous step.

TESTO Saveris Specifications

General

Humidity Range	0 to 100 %RH
Measurement Parameters	Temperature, Humidity
Data Transmission	Wireless
Alarm Function	Yes
Resolution	0.1 °C, 0.1 %RH
Radio Frequency	868 MHz, 915 MHz
Data Storage	Internal memory, Cloud
Power Supply	Battery