Need help?Do you have a question about the Tokheim WWC T1 and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Output | RS-485 |
| Power Supply | 24 VDC |
| Operating Temperature | -40°C to +60°C |
| Model | Tokheim WWC T1 |
Specifies requirements for qualified personnel performing procedures.
Outlines essential health, safety, and hazard information.
Lists and briefly describes the primary modules and components of the WWC.
Details the functionality and menus for LPG setups on the WWC.
Covers the regulation of flow and valve types in LPG dispensers.
The standard tool for programming and calibrating the WWC and VRC.
Menu entered after cold start or detected error for mandatory setup.
Step-by-step instructions to enter the maintenance menus.
Accessing and interpreting the calculator's error log and event data.
Procedures for performing French and Esso leak tests.
Configuration of LPG nozzle switch, delay timers, and pulse menus.
Procedure to reset thermal protection for pump motors.
Functions for detecting leaks, including Vapour, Flow, and Esso.
Setting fraud sensors and displaying fraudulent status of configured products.
Configuration for fuel leak tests, including volume, time, and test type.
Allows testing and calibration of calculator functions via test delivery.
Enables manual fuel dispensing during power failure using backup battery.
Maps pump controller product numbers to WWC internal product codes.
Configures Vapour Recovery settings based on VRC board detection.
Configuration and read-only access for Axial Flow Volume Meters.
Changes sensor numbers to match pre-installed sensors with correct functions.
Initial setup process for the Station Manager PIN code.
Steps to change the existing Station Manager PIN code.
To Next Page
