Tokheim WWC T1 - Blend Ratio; Set up PIN Code (Fuel Leak Detection Only)

WWC T1 Set Up & Maintenance Manual Maintenance Modes
Document Ref 905675-001 Rev 2 Page 6-17
6.17.1 SET UP PIN CODE (FUEL LEAK DETECTION ONLY)
A special Personal Identification Number (PIN) code is required to store any
changes to the Fuel Leak Detection settings.
Note : The changed values will only be stored in Eeprom if a correct PIN code is entered.
6.18 Blend Ratio
Blending allows two fuel grades to be mixed to give a third grade blend with another
octane.
For more information, refer to section 2.5.1.
INFORMATION TO BE INSERTED
Issue B
Display Explanations/comments
SEtUP
Set Up PIN Code menu.
PIncd
Set Up and Pincd are flashing.
Press 7 to continue.
E n t E r Enter PIN code menu.
PIncd The left - is flashing.
-
--
-
Enter the four digit Set Up PIN code.
If an incorrect PIN code is entered, error will flash for approx. 3
Er ror
seconds then return to the previous menu to allow the correct
Set Up PIN code to be entered.