WWC T1 Set Up & Maintenance Manual Maintenance Modes
Document Ref 905675-001 Rev 2 Page 6-5
6.4 Exit Maintenance Mode
If any Maintenance functions have been changed, the calculator automatically prompts
for the storage of these modifications in Eeprom before exiting the Maintenance Functions
menu.
Display Explanations/comments
Press 0 to return to Diagnostic Log (first menu).
Press 0 to return to Configuration.
Configuration menu.
conF
To exit Maintenance Mode, check all nozzles are replaced and
press OFF.
E E P r o Store Eeprom menu (only if changes have been made).
StorE Press 9 to toggle between yes (store changes in Eeprom) and
YES
no (do not store changes).
If yes is selected, all information stored in Eeprom is erased and
overwritten with the new configuration data.
Error If error is displayed then one of the parameters entered is invalid
or one of the nozzles has not been replaced.
Issue A
To Next Page
Loading...