Page 12-4 Document Ref 905675-001 Rev 2
Appendix WWC T1 Set Up & Maintenance Manual
12.2 Appendix B - Country Codes
Key:-
*
In USA the pulser resolution is 0,0005 Gallons. Therefore these values are expressed in
this unit.
Comma Position ,
The position of the comma on the displays for amount/volume/unit price is counted from
the RIGHT side. The software comma position for the unit price can differ from the
display.
Hose Expansion Time and Value
These parameters are used to compensate the volume of fuel which is counted during the
pressurising stage of the hose at the beginning of a delivery. The time factor is in multiples
of 10 milliseconds (ms) and the volume in centilitres (cl). The hose expansion functionality
is only executed when the dispenser has been idle for more than an hour.
All countries, except France, have a fixed value of 30/8 for hose expansion. i.e. volumes
less than 8 cl during the first 300 ms are not counted. In France, different values apply
and it is possible to switch off the hose expansion functionality by setting the values to 0.
The default values for France are 200/3 i.e. volumes less than 3 cl during 2 seconds will
not be taken into account.
Rounding Type
Type 1 1 by 1 rounding
Type 2 5 by 5 rounding
Type 3 10 by 10 rounding
Pulse Hide
This parameter defines the number of pulses hidden at the start of a delivery. The pulses
are counted but not shown on the calculator display. This parameter will vary according
to the set up and number of meters involved.
In all countries, except France, the parameters are set to 2 i.e. the first two pulses are
counted but not displayed.
Issue A
To Next Page
Loading...