Tokheim WWC T1 - 6.3 Access the Maintenance Functions

Page 6-4 Document Ref 905675-001 Rev 2
Maintenance Modes WWC T1 Set Up & Maintenance Manual
6.3 Access the Maintenance Functions
Display Explanations/comments
Press ON to enter Configuration.
conF
Press 5 to continue.
Technicians menu.
tEcH
Tech is flashing.
Press 7 to continue.
tEcH
Technician PIN code menu.
PIncd
Tech and Pincd are flashing.
Press 7 to continue.
E n t E r Enter PIN code menu.
PIncd The left - is flashing.
-
- - - Enter the Technician's four digit PIN code.
If an incorrect PIN code is entered, error will flash for approx. 3
Er ror
seconds then return to the previous menu to allow the correct PIN
code to be entered.
Note : While the error message is flashing, use 0 to exit the PIN
code menu and return to the previous menu.
Issue A