Tokheim WWC T1 - 8.2 Change PIN code

WWC T1 Set Up & Maintenance Manual PIN Codes
Document Ref 905675-001 Rev 2 Page 8-3
8.2 Change PIN code
Issue A
(Cont.)
Display Explanations/comments
XXXXXX All displays show X .
XXXXXX
XXXX
Select ON
c o n F Configure PIN code menu.
PIncd
Press 7 to continue.
E n t E r Enter the correct four digit Station Manager PIN code.
PIncd
----
Configuration menu.
conF
Press 4 to enter PIN code menu.
PIN code menu.
PIncd
Press 7 to continue.
o L d Enter the old four digit Station Manager PIN code.
PIncd
----
E n t E r Enter the new four digit PIN code to use for Station Manager PIN.
PIncd Note : To disable PIN code, enter 0000 as the new PIN code.
----
v E r I F Y Verify the new four digit Station Manager PIN by entering the
P I n c d same four digits again.
----
Back to Configuration menu.
conF
Select OFF