WWC T1 Set Up & Maintenance Manual Maintenance Modes
Document Ref 905675-001 Rev 2 Page 6-37
6.32 Nozzle Sensor Definition
This menu allows sensor numbers to be changed in order to match the pre-installed sensors
with the correct functions. e.g. For replacing of a faulty sensor with a new one with a
different address.
Note : it is not possible to use double addresses in one dispenser.
6.32.1 KERNEL VERSION >= 03.08
Issue B
Note : The Change Sensor and Define Sensor menus are not visible with IFSF kernel
versions 03.04 to 03.17.
Note : The Program Sensor and Erase Sensor menus are not visible with all applications
kernel versions >= 03.08.
6.32.2 KERNEL VERSION >= 03.03
(CONT.)
Display Explanations/comments
n b U S Nozzle Sensor Definition menu.
Press 8 to enter this menu.
Display Explanations/comments
n b U S Nozzle Sensor Definition menu.
Press 8 to enter this menu.
d I S P L Display Sensor submenu.
S E n S o r All installed sensors are displayed with their specific functions.
Press 8 to enter this submenu.
Press 7 to skip and go to nrext menu (Sensor Activate).
Press 0 to exit nbus menu.
S E n 0 1 The first sensor present is displayed with its function.
r n o 1 If no function is associated with the sensor, no Fun is displayed.
Press 9 to repeat for each installed sensor.
Press 7 to save and continue.
Press 0 to return to nbus menu.
To Next Page
Loading...