Page 6-38 Document Ref 905675-001 Rev 2
Maintenance Modes WWC T1 Set Up & Maintenance Manual
Issue B
(CONT.)
Display Explanations/comments
S E n S o r Sensor Activate submenu.
t E S t The current activated sensor will be displayed with its function
as described above.
Press 7 to go to next submenu (Change Sensor).
Press 0 to return to nbus menu.
c H A n G E Change Sensor submenu.
S E n S o r The function of a sensor can be changed in this submenu.
Press 8 to enter this menu.
Press 7 to go to next menu (Define Sensor).
Press 0 to return to nbus menu.
SEn 01
The first sensor is displayed with its function (top line flashing).
rno1Press 7 to toggle between top line (sensor number) and second
line (sensor function).
Press 9 to display next installed sensor and its function.
Select the sensor to be changed.
Press 7 to change sensor function.
SEn 01 Press 9 to display the next function for the selected sensor.
rno1
Press 7 to toggle between top line (sensor number) and second
line (sensor function).
Change all sensors as required.
Press 0 to continue.
S E n 0 1 Store changes setting.
rno2Press 9 to toggle between yes (store changes) and no (exit
yes
without storing changes).
Press 0 to save and continue.
d E F I n E Define Sensor submenu.
S E n S o r The function of a sensor can be re-defined in this menu.
Press 8 to enter this submenu.
Press 7 to return to Display Sensor menu.
Press 0 to return to nbus menu.
A c t v t E Activate sensor submenu.
r n o 1 This menu asks for activation of each sensor for selected setups
which will store the current settings.
Press 7 to go to the next sensor if no sensor is present.
Press 0 to go to next menu.
E r A S E Erase Sensor submenu.
S E n S o r Activates a special sequence for erasing sensors.
To Next Page
Loading...