Tokheim WWC T1 - Page 107

WWC T1 Set Up & Maintenance Manual Maintenance Modes
Document Ref 905675-001 Rev 2 Page 6-39
Issue B
Display Explanations/comments
Press 8 to enter this submenu.
Press 0 to return to nbus menu.
Press 7 to skip and go to next menu (Program Sensor).
E r A S E All connected sensors are erased.
donE
Press 8 to re-activate the function.
Press 7 to return to Display Sensor menu.
Press 0 to return to nbb menu.
P r o G r Program Sensor submenu.
S E n S o r Re-defines the function of a sensor.
Press 8 to enter this submenu.
Press 7 to return to Display Sensor menu.
Press 0 to return to nbb menu.
SEn 01
The first non-present sensor is displayed (and flashing).
Press 9 to display the next non-present sensor.
Press 8 to enter programming sequence.
Press 0 to exit this submenu.
SEn 01
Sensor 1 is programmed.
donE
Press 9 to display the next non-present sensor.
Press 0 to exit this submenu.
SEn 01
Sensor 1 is not programmed.
Er ror
Press 9 to display the next non-present sensor.
Press 0 to exit this submenu.