Tokheim WWC T1 - Address Conflict

Page 5-14 Document Ref 905675-001 Rev 2
Set Up Modes WWC T1 Set Up & Maintenance Manual
Issue B
5.4.2 ADDRESS CONFLICT
(CONT.)
Address Conflict
If an address conflict is detected, the display will flash error in
error
the volume line for approx. 3 seconds.
HoSE X
AFM Address menu.
rIGHt
All invalid AFM addresses must be set.
AF
Press 8 to scroll through all available AFM addresses.
Note : During manufacture, all addresses are set to a default
address - refer to the section 5.4.3.
Disconnect all AFMs and verify each address one-by-one.
If an AFM is replaced in the field, only this address needs to be
changed then followed by a forced re-scan.
Press 8 to scroll through all AFMs as required.
Press 7 to save and continue.
dIScon
Disconnect All AFMs menu.
ALL AF
All AFMs must be disconnected in order to proceed.
Press 0 to return to previous menu.
Press 7 to continue.
HoSE X
AFM Address menu.
rIGHt Press 8 to select a hose.
AF
Press 7 to continue.
conn
Connect AFM menu.
HoSE X
Connect the AFM for hose X (r=right/side A; L=left/side B)
r
oPEn
Open Seal menu (only if seal is closed).
SEAL
This request will display for approx. 3 seconds.
r
Press 7 to open the seal and continue.