Tokheim WWC T1 - Local Preset Values; Maintenance Mode; Node Address

Page 6-18 Document Ref 905675-001 Rev 2
Maintenance Modes WWC T1 Set Up & Maintenance Manual
Issue B
6.19 Local Preset Values
Preset values are predefined (selected from a pick list) and are dependent upon the comma
position as defined in Appendix A.
For more information, refer to section 2.5.2.
6.20 Node Address
This function is required for multi drop communication links, for example IFSF and
Tatsuno, to select the address of the calculator on the network. The layouts and ranges
for this function will vary between applications.
For more information, refer to section 2.5.3.
Display Explanations/comments
P r E S E t Local Preset menu.
SE t UP
r1
Set the value for the right side (side A):-
r 1 is flashing. Press 9 to scroll through the available preset
options.
Press 7 to save and continue.
P r E S E t Set the value for the left side (side B):-
SE t UP L 00 is flashing. Press 9 to scroll through the available preset
L00
options.
Press 7 to save and continue.
Display Explanations/comments
n o d E Node Address menu.
Add r
r1
Set the value for the right side (side A):-
1 is flashing. Press 9 to scroll through available addresses.
Press 7 to save and continue.
n o d E Set the value for the left side (side B):-
Add r 1 is flashing. Press 9 to scroll through available addresses.
l1
n o d E For IFSF application, the left and right sides are combined as
A d d r shown.
00
Press 7 to save and continue.