Page 1-2 Document Ref 905675-001 Rev 2
Introduction WWC T1 Set Up & Maintenance Manual
1 INTRODUCTION
1.1 How to Use this Manual
It is recommended that all relevant persons familiarise themselves with the contents of this
manual prior to carrying out any operations or procedures.
This manual is divided into sections which are described as follows: -
Section 1 - Introduction
This section contains information on how to use the manual, the scope of equipment covered,
recommendations on qualified technicians and contact information. It also includes relevant
health and safety information and certification relating to the product.
Section 2 - Product Information
This section contains the system description and operating principles of the WWC T1
Calculator. It also describes the main components, their configurations and functions
including the service keypads.
Section 3 - LPG Specification
All additional information relating to LPG options is contained in this section.
Section 4 - Service Keypad
This section describes the functions of the various keypads.
Section 5 - Set Up Modes
This section provides instructions for cold start, warm start and service start of the product.
Section 6 - Maintenance Mode
All aspects relating to the maintenance of the equipment are covered in this section.
Section 7 - Application Mode
This section contains information on the EPS, IFSF and ZSR Application Modes.
Section 8 - PIN Code
This section contains information on how to change the PIN code.
Section 9 - Totals
Instructions on how to read totals is contained in this section.
Section 10 - Unit Prices
This section contains information on setting and changing the Unit Prices.
Section 11 - Inspection Functions
All information relating to the Inspection Function is contained in this section.
Section 12 Appendices
This section contains the appendices.
Issue A
To Next Page
Loading...