Page 2-16 Document Ref 905675-001 Rev 2
Product Information WWC T1 Set Up & Maintenance Manual
Issue B
- volume unit (number of cl/pulse) 1 to 10 (default = 1)
- volume period (value * 0.25 ms) 5 to 40 (default = 5)
- amount unit (number of units/pulse currency unit)
1 to 10 (default = 1)
- amount period (value * 0.1 ms) 10 to 99 (default = 10)
•Fleet Functionality
In addition to the volume and amount pulses, the “Fleet Functionality” is added
for outdated interfaces to certain controllers.
An OCB output (OUT_SPARE) is reserved to indicate a request for release
and an input (OPT_INPUT) is reserved for the “controller” to release the
dispenser. This requires a special release sequence:-
- calculator will set OUT_SPARE if a nozzle is lifted
- the filling can only start if the controller sets the OPT_INPUT
- the controller can interrupt or stop the filling when resetting the
OPT_INPUT
This release functionality is activated via the RELEAS submenu in the OCB
menu.
For the applicable input and output refer to the OCB definitions in the Appendix.
2.5.3 FUNCTIONALITIES PER DISPENSER
Common Set-Up Codes
The common set-up codes have been defined for the new dispenser range in the
following table.
Refer to the hydraulic flow diagrams for a symbolic drawing regarding supported
hydraulic configurations.
Note : there is also a fleet version of WWC available (volume only display).
Hydr
Setup No
Sided
Additional
Description
No of
Products
Flow Rates/Products Drawing No
9235110557
900236
01.07 51 Double 4
130 l/min SAT and 3x40 l/min per
side
9235110???
9235110619
900246
SHS with 1 product on both sides; 9235110580
130 l/min/SAT and 3x40 l/min per
side
900237
9235110581
900238
>
03.11 53 Double 1 motor 1 130 l/min/SAT 900238
9235110582
900239
9235110583
900240
>
5 40/80 l/min button per side
130l/min SAT (SHS on Mainboard)
Kernel
Version
all 50 Double
1
4
>
02.00 51 Single
01.09 53 Double
>
01.09 52 Double
80 l/min SAT and 3x40 l/min per
side
130 l/min/SAT and 1x40 l/min
>
01.09
>
01.09 55 Double
4
1
160 l/min/SAT154 Double
To Next Page
Loading...