Tokheim WWC T1 - 6.10 Leak Detection Functionality

Page 6-12 Document Ref 905675-001 Rev 2
Maintenance Modes WWC T1 Set Up & Maintenance Manual
6.10 Leak Detection Functionality
This menu is displayed when the hose is activated and ready for use.
6.10.1 VAPOUR LEAK DETECTION (FRANCE ONLY)
When a leak is detected, the calculator will not allow the motor to re-start without
user intervention via this menu. The Flow Leak menu changes into:-
Issue A
6.10.2 FLOW PROTECTION RESET (AFM LEAK DETECTION)
When a flow protection error is detected, the calculator will not allow the motor
to re-start without user intervention via this menu. The Flow Leak menu changes
into:-
Display Explanations/comments
F L P r o t Flow Protection menu.
Ho
r1
The associated product must be reset to on to allow the motor to
oFF
re-start.
Press 8 to increase the product number (right then left).
Press 9 to toggle between on and off .
Press 7 to save and continue.
Display Explanations/comments
F L L E A Fuel Leak menu.
Ho
r1
The first product is displayed.
on X
Press 8 to increase the product number (right then left).
Press 9 to toggle between on and off.
X refers to the number of leak defaults detected (0,1 or 2).
Note : For kernel versions <3.13, X is not present.
Press 7 to save and continue.
Display Explanations/comments
F r L E A French Vapour Leak menu.
Ho
r1
The associated product must be reset to on to allow the motor to
oFF
re-start.
Press 8 to increase the product number (right then left).
Press 9 to toggle between on and off .
Press 7 to save and continue.