WWC T1 Set Up & Maintenance Manual Set Up Modes
Document Ref 905675-001 Rev 2 Page 5-15
Issue B
Address Conflict
cHAnGE
Change Address menu(only if seal is open).
Add r
The address will correspond to the previously selected set up and
r
number of hoses - refer to section 5.4.3.
Note : This display may only be visible briefly depending on the
time it takes to access the AFM.
cLoSE
Close Seal address (only if address has been changed).
SEAL
Close the seal to save the new settings.
AF
Press 7 to close the seal and continue.
HoSE x
AFM address menu (only if seal has been closed).
rIGHt
Repeat the procedures for the other hoses as required.
AF
Press 8 to scroll through all AFMs as required.
If connected, the AFM will display a valid address.
Press 0 to return to Hose 1 Right (or back to the start of the set
up procedures to re-scan the new settings).
AF
AFM Set Up menu (only if addresses have been set for all
Se tUP
connected AFMs.
The new settings require to be re-scanned.
Press 0 to re-scan then follow procedure for No Address Conflict
To Next Page
Loading...