Tokheim WWC T1 - Page 65

WWC T1 Set Up & Maintenance Manual Set Up Modes
Document Ref 905675-001 Rev 2 Page 5-13
Issue B
Display Explanations/comments
Conversion:
HEX round 32768
K-factor
De
z
Press 7 to save and continue.
cLoSE
Close Seal menu.
SEAL
Close the seal to save the new settings.
AF y
Press 7 to save and continue.
StorE
Store Good menu.
Good
This menu is displayed for approx. 3 seconds after all seals have
AF y
have been closed and all parameters saved to AFM.
If there is an error, the display will flash error for approx. 3 seconds
then re-starts after the AFM Scan setting.
HoSE x
AFM address menu.
rIGHt
The AFM is now configured and should be recognised as being
AF y
connected and a working component within the system.
Press 8 to scroll through all AFMs as required.
Press 0 to return to AFM Set Up menu.
AF
AFM Set Up menu.
Se tUP
Press 8 to re-scan and re-start the set up process.
Press 7 or 0 to save and continue.
000000
All displays show zero.
000000
0000
Press 7 or 0 to complete AFM set up and save settings.