Toro 30413 Service Manual

Groundsmaster 4100--D/4110--D Cutting DeckPage 8 -- 13
Cutting Deck Link Service
Disassembly (Fig. 10)
1. Press bushings from top of link.
2. Remove dust cap and retaining ring from link.
3. Presstaperedstudwithsphericalbearing,flatwash-
ers and flange nut from link.
4. Removeflangenutandpresssphericalbearingfrom
tapered stud.
Assembly (Fig. 10)
1. Install new spherical bearing onto tapered stud. Se-
cure bearing with flange nut. Torque nut from 30 to 40
ft--lb (41 to 54 N--m).
2. Position flat washer in both sides of spherical bear-
ing.
3. Presstaperedstudwithsphericalbearing,flatwash-
ers and flange nut into link. Secure spherical bearing
into link with retaining ring.
4. Press bushings into top bore of link.
5. If cap screw and jam nut were removed from rear
link,installcapscrewtoallow1.625”(41.3mm)between
the head of the screw and the side of the link (Fig. 11).
6. After link is installed on deck, check distance be-
tweencenterdeckbladeandwingdeckblade.Readjust
cap screw and jam nut on rear link if needed (see Wing
Deck Service in this Chapter).
1. Link
2. Bushing (2 used)
3. Tapered s tud
4. Spherical bearing
5. Flat washer (2 used)
6. Retaining ring
7. Flange nut
8. Dust cap
Figure 10
30 to 40 ft--lb
(41to54N--m)
1
3
6
7
4
5
2
8
1. Rear link
2. Cap screw
3. Hex jam nut
Figure 11
1.625”
(41.3 mm)
1
2
3
Cutting
Deck

Toro 30413 Specifications

General

Brand	Toro
Model	30413
Category	Lawn Mower
Language	English