Groundsmaster 4100--D/4110--D Hydraulic SystemPage 4 -- 31
Traction Circuit Problems
Problem Possible Cause
Machine operates in one direction
only.
Traction control linkage is faulty.
Traction relief valve is faulty.
Traction pedal is sluggish. Traction control linkage is stuck or binding.
Charge pressure is low.
Piston (traction) pump servo control valve orifices are plugged or
damaged.
4WD manifold PD1 and PD2 pilot directional valves seals are leaking
or damaged.
Machine travels too far before stop-
ping when the traction pedal is re-
leased.
Traction linkage is out of adjustment.
Traction pedal does not return to neutral.
Charge pressure is low.
Piston (traction) pump servo control valve orifices are plugged or da-
maged.
Traction power is lost or unit will not
operate in either direction.
Hydraulic reservoir oil level is low.
Piston pump by--pass valve is open or damaged.
Charge pressure is low.
Traction circuit pressure is low.
Front wheel motor couplers are damaged.
Low speed (4WD) will not engage. Electrical problem exists (see Chapter 5 -- Electrical System).
Solenoid valve (SV) in 4WD manifold is faulty.
Cartridge valve(s) in 4WD manifold is faulty.
Drive gear on rear axle motor or driven gear for r ear axle is loose or
damaged.
Rear axle motor is damaged.
Low speed (4WD) will not disen-
gage.
Electrical problem exists (see Chapter 5 -- Electrical System).
Solenoid valve (SV) in 4WD hydraulic manifold is faulty.
Cartridge valve in 4WD manifold is damaged or sticking.
Hydraulic
System
To Next Page
Loading...
Need help?
General
