Toro Reelmaster 3100-D - Page 319

RemovingtheBedbarAssembly(continued)
4.Loosenthelocknuts(item10)oneachbedbarpivotbolt.
5.Removetwo(2)bedbarpivotbolts(item9),two(2)metalwashersandfour
(4)plasticwashersfromthecuttingunitsideplates.
6.Removethebedbarassemblyfromcuttingunit.
7.Inspectangebushings(item7)andrubberbushings(item6)insideplates
forwearordamage.Removebushingsandreplaceifnecessary.
InstallingtheBedbarAssembly
g343483
Figure170
1.Cuttingunitsideplate
5.Metalwasher
2.Locknut6.Plasticwasher
3.Bedbarpivotbolt7.Rubberbushing
4.Flangebushing8.Bedbar
1.Ifrubberbushingwasremovedfromeithercuttingunitsideplate,installa
newbushing.Thebushingshouldbeinstalledushwiththeinsideofthe
sideplate(Figure170).
2.Ifremoved,installtheangebushingswithangefacingoutward.Apply
anti-seizelubricanttoinsideofangebushing.
3.Applyanti-seizelubricanttothebedbarthreadsandtheshoulderareaof
eachbedbarpivotbolt.
4.Slideonemetalwasherandoneplasticwasherontoeachbedbarpivotbolt.
CAUTION
Contactwiththereel,bedknifeorothercuttingunitpartscanresult
inpersonalinjury.Useheavygloveswhenhandlingthebedbar.
5.Positionbedbarintocuttingunit.Makesurethatthetopofeachbedbararm
isbetweenwasher(item4)andadjusterscrewange.
6.Positionaplasticwasherbetweenbedbarandeachcuttingunitsideplate
(Figure170).
Reelmaster
®
3100-D/3105-D
Page8–11
DPACuttingUnits:ServiceandRepairs
20252SLRevA