3
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
ADJUSTMENT
3 - 7
3.1.5 Adjustment of the transfer belt due to environmental factors
The length of the transfer belt may vary depending on environments such as temperature or humidity.
When the belt length varies, the leading position of an image also varies. Therefore, check image
position in the secondary scanning direction after installation or parts replacement because there is
difference between the environments of an installation site and a factory where the equipment was
shipped. (Although image adjustment is already performed at the shipment from the factory, this
adjustment must be performed again in the installation site.) If required, perform “Leading edge position
adjustment / Common items (05-408)”.
P.3-72 "3.10.1 Adjustment of the transfer belt due to environmental factors"
To Next Page
Loading...
