Toshiba e-STUDIO2020C User Manual

e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
7 - 32
7.2.9 Electronic key re-registration using the one-time dongle
[A] Re-registration when the board is replaced
The Electronic key registered using the one-time dongle can be re-registered only in the same
equipment. When the SYS board or SRAM board (for SYS board) is replaced, follow the procedures for
re-registration given below.
(1) After the SYS board or SRAM board is replaced, set up the equipment referring to the following
procedures.
 P.7-23 "7.2.4 Precautions and Procedures when replacing the SYS board"
 P.7-25 "7.2.6 Precautions and procedure when replacing the SRAM board (for the SYS
board)"
(2) Reinstall the options referring to the following procedures.
 P.7-23 "[D] Reinstall options"
 P.7-28 "[J] Reinstall options"
(3) Perform 08-3840 with the one-time dongle previously used for registering the Electronic key.
(4) When the authentication succeeds, the re-registration screen appears and the available re-
registration numbers are displayed after the option names.
(5) Perform the registration in the same manner as a regular one.
Note:
This procedure is available only with the one-time dongle used for the previous registration, since
the model information registered in it is utilized. Use the same one-time dongle and the
equipment when registering the Electronic key.
[B] Re-registration when the equipment is replaced due to malfunction
When the equipment has to be replaced due to a malfunction, return the Electronic key registered in the
equipment to the one-time dongle and register it to the new equipment following the procedure below.
Note:
The Electronic key of the IPSec option (GP-1080) cannot be re-registered.
(1) Start up with the Setting mode (08).
(2) Perform 08-3870 and check the registered Electronic key.
(3) Connect the one-time dongle used for registering the Electronic key to the USB port of the
equipment.
Note:
The one-time dongle to be used is the one for the previous registration of the Electronic key.
(4) Perform 08-3841. The Electronic keys which can be returned to the one-time dongle are
displayed.
(5) Select one and press the [RETURN] button.
Note:
The Electronic key is deleted from the equipment and is stored in the one-time dongle.
(6) After the equipment is replaced, start up with the Setting mode (08).
(7) Connect the one-time dongle to the USB port and perform 08-3840.
(8) Perform the re-registration in the same manner as a regular one.

Toshiba e-STUDIO2020C Specifications

General

Brand	Toshiba
Model	e-STUDIO2020C
Category	All in One Printer
Language	English