e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
7 - 28
[I] Set EFI Printer Board
If the EFI Printer Board (GA-1211) is installed, perform the following procedure.
(1) Turn the power OFF.
(2) Start the setting mode (08).
(3) Initialize the EFI Printer Board (08-700).
(4) Turn the power OFF.
[J] Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
• Meta Scan Enabler (GS-1010)
• External Interface Enabler (GS-1020)
• IPSec Enabler (GP-1080)
When GP-1070 (Data Overwrite Enabler) has been installed, “F200” service call occurs.
In this case, perform cancelling the “F200” service call (installing the OS / HDD SYS / PFC Firmware /
Engine MainFirmware / Scanner Firmware using the USB media), and then install GP-1070 (Data
Overwrite Enabler) again.
To Next Page
Loading...
Need help?
General
