To Next Page

To Previous Page

ADJUSTMENT

3 - 59

3.4.7 Fine adjustment of black density

The density of black side on scanned image is adjusted at color-scanning.

Note:

Be careful for the value not to be too large since the gradation is reproduced worse in darker

side.

(1) While pressing [0] and [5] simultaneously, turn the power ON.

(2) Key in the codes and press the [START] button.

(3) Key in the adjustment values. Acceptable values: 0 to 4. (To correct the value once keyed in,

press the [CLEAR] button.)

(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory. → The equipment

goes back to the ready state.

(5) Let the equipment restart and perform the scanning job.

(6) If the desired image has not been attained, repeat step (1) to (5).

3.4.8 RGB conversion method selection

The color space conversion method of image is decided at color-scanning.

(1) While pressing [0] and [5] simultaneously, turn the power ON.

(2) Key in the codes and press the [START] button.

(3) Key in the adjustment values. Acceptable values: 0 to 3. (To correct the value once keyed in,

press the [CLEAR] button.)

(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory. → The equipment

goes back to the ready state.

(5) Let the equipment restart and perform the scanning job.

(6) If the desired image has not been attained, repeat step (1) to (5).

Code Original mode Remarks

1075 Text The larger the value is, the black side of the image becomes darker.

Acceptable values: 0 to 4 (Default: 0)

1076 Printed Image

1077 Photo

8371 User custom

Code Original mode Remarks

1080 Text 0: sRGB, 1: AppleRGB, 2: ROMMRGB, 3: AdobeRGB

(Default: 0)

1081 Printed Image

1082 Photo

8372 User custom

Toshiba e-STUDIO2020C User Manual

Questions and Answers: