1
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
SPECIFICATIONS/ACCESSORIES/OPTIONS/SUPPLIES
1 - 13
1.3 Options
• The bridge kit (KN-4520) is necessary for installation of the finisher (MJ-1101/1030/1031).
• The finisher (MJ-1101) is necessary for installation of the hole punch unit
(MJ-6101N/E/F/S/E-C).
• The finisher (MJ-1030) is necessary for installation of the hole punch unit (MJ-6004N/E/F/S).
• The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1050/C) and
the bluetooth module (GN-2010).
Original Cover KA-3511PC/PC-C
Reversing Automatic Document Feeder (RADF) MR-3018
Large Capacity Feeder (LCF) KD-1024LT/A4/C
Paper Feed Pedestal (PFP) KD-1023/C
Drawer Module MY-1032/C
Finisher MJ-1101
Saddle Stitch Finisher MJ-1030/C
Hanging Finisher MJ-1031/C
Hole Punch Unit MJ-6101N/E/F/S/E-C (for MJ-1101)
MJ-6004N/E/F/S (for MJ-1030)
Staple Cartridge STAPLE-2400 (for MJ-1101)
STAPLE-2000 (for MJ-1030/1031)
STAPLE-600 (for saddle stitcher of
MJ-1030)
Bridge Kit KN-4520
Work Table KK-3511
EFI Printer Board GA-1211
FAX Unit GD-1250NA/AU/AS/EU/C/TW
2nd Line for Fax Unit GD-1260NA/AU/EU/C/TW
Wireless LAN Module GN-1050/C
Bluetooth Module GN-2010
Antenna GN-3010
Data Overwrite Enabler GP-1070
Meta Scan Enabler GS-1010
External Interface Enabler GS-1020
IPSec Enabler GP-1080
Harness Kit for Coin Controller GQ-1110
e-BRIDGE ID Gate (HID) KP-2004
e-BRIDGE ID Gate (MIFARE) KP-2005
Imaging Acceleration Board GE-1170
Damp Heater Kit MF-3500CU/CE
Desk MH-1700
To Next Page
Loading...
Need help?
General
