3
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
ADJUSTMENT
3 - 41
3.2.14 Text/Photo reproduction level adjustment
Text/Photo reproduction level at the Full color mode, Auto color mode and Gray scale mode can be
adjusted.
Text/Photo reproduction level adjustment can be switched to “Photo oriented 1”, “Photo oriented 2”,
“Text oriented 1” or “Text oriented 2” in the following codes.
<Adjustment Mode (05)>
• The text reproduction level is lower when the mode is switched from the default value to the
Photo oriented 1 or Photo oriented 2. (The text reproduction level in Photo oriented 2 is lower
than that in Photo oriented 1.)
• Changing the setting value from default value to the Text oriented 1 or Text oriented 2 causes
image noise in the printed photo image with few lines per inch. (Photo oriented 2 causes more
image noise than Photo oriented 1.)
<Procedure>
The procedure is the same as that of P.3-31 "3.2.2 Density adjustment".
3.2.15 Black reproduction switching at the Twin color copy mode
Black reproduction can be switched at the Twin color (Black/Red) copy mode.
<Adjustment Mode (05)>
The boundary between Red and Black may not be smooth when the setting value is “1”.
<Procedure>
The procedure is the same as that of P.3-31 "3.2.2 Density adjustment".
Mode Mode
Item to be adjusted Contents
Text/Photo User custom
1725 7841 Text/Photo
reproduction level
adjustment
0: Default
1: Photo oriented 2 (The printed image reproduction
level higher than that of the Photo oriented 1)
2: Photo oriented 1 (The printed image reproduction
level higher than that of the Default)
3: Equivalent to the Default
4: Text oriented 1 (The text reproduction level higher
than that of the Default)
5: Text oriented 2 (The text reproduction level higher
than that of the Text oriented 1)
Mode Code Item to be adjusted Remarks
Twin color copy mode
(Black/Red)
1761 Black reproduction
switching
0: Default
1: Black reproduction oriented
To Next Page
Loading...
Need help?
General
