EasyManuals Logo

Toshiba e-STUDIO2020C User Manual

Toshiba e-STUDIO2020C
546 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #435 background imageLoading...
Page #435 background image
7
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
REPLACEMENT OF PC BOARDS/HDD
7 - 15
7.2 Precautions, Procedures and Settings for Replacing PC
Boards and HDD
7.2.1 Precautions when replacing PC boards
The ID for each equipment is registered on the LGC board, the IMG board, the SYS board and the
SLG board. So, if their replacement is required, be sure to replace only one board at a time.
If more than one of the LGC board, the IMG board and the SYS board require replacement, replace
them in the following procedure.
1. First, replace one of the board to be replaced.
2. Turn the power ON and confirm that “READY” is displayed.
3. Turn the power OFF.
4. Replace another board that requires replacement.
5. Repeat steps 2 to 4.
The LGC board and IMG board can be replaced without other settings.
When the HDD requires replacement, see “7.2.3Precautions and procedures when replacing the
HDD“.
When the SYS board requires replacement, see “7.2.4Precautions and Procedures when replacing
the SYS board“.
When the SLG board requires replacement, see “7.2.5Procedures and settings when replacing the
SLG board“.
When SRAM requires replacement, see “7.2.6Precautions and procedure when replacing the
SRAM board (for the SYS board)” / “7.2.7Procedures and settings when replacing SRAM board (for
LGC board)“.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba e-STUDIO2020C and is the answer not in the manual?

Toshiba e-STUDIO2020C Specifications

General IconGeneral
BrandToshiba
Modele-STUDIO2020C
CategoryAll in One Printer
LanguageEnglish

Related product manuals