To Next Page

To Previous Page

PREVENTIVE MAINTENANCE (PM)

5 - 5

5.3 General Descriptions for PM Procedure

(1) Preparation

• Ask the user about the current conditions of the equipment and note them down.

• Before starting maintenance, make some sample copies and store them.

• See the replacement record and check the parts to be replaced in the PM support mode (6S-

2) or list printing mode (9S-103).

6S-2 : [6] + [START] + [POWER] ON  [2]  [START]

9S-103 : [9] + [START] + [POWER] ON  [103]  [START]

Fig. 5-1

• Turn OFF the power and make sure to unplug the equipment.

(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the

Service Manual if necessary.

(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and

make some copies to confirm that the equipment is working properly.

PM SUPPORT CODE LIST

MM-DD-YY HH:MM

UNIT OUTPUT PAGES/ PM OUTPUT PAGE/ DRIVE COUNTS PM DRIVE COUNTS

DEVELOP COUNTS DEVELOP COUNTS

DRUM(K) 342 70000 4377 130000

DRUM BLADE(K) 342 70000 4377 130000

DRUM BRUSH(K) 342 70000 4377 130000

GRID(K) 342 70000 4377 130000

MAIN CHARGER NEEDLE(K) 342 70000 4377 130000

CHARGER CLEANING PAD(K) 177 70000 3681 130000

Toshiba e-STUDIO2020C User Manual

Questions and Answers: