e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 6
EA80 Finisher jam
(Saddle stitcher
section)
Stapling jam: Stapling is not performed properly.
[MJ-1030]
P. 6-47
EA90 Door open jam: The delivery cover or inlet cover
has opened during printing [MJ-1030].
P. 6-47
EAA0 Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1030]
P. 6-47
EAB0 Transport stop jam: The paper which passed
through the inlet sensor does not reach or pass
No.1 paper sensor, No. 2 paper sensor, No.3 paper
sensor or delivery sensor. [MJ-1030]
P. 6-47
EAC0 Transport delay jam: The paper which has reached
the inlet sensor does not pass through the inlet
sensor. [MJ-1030]
P. 6-48
EAD0 Other paper jam Print end command time-out jam: The printing has
not finished normally because of the
communication error between the SYS board and
LGC board at the end of printing.
P. 6-49
EAE0 Finisher jam Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the
finisher.
P. 6-49
EB30 Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
P. 6-49
EB50 Paper transport jam Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 6-31
EB60 Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 6-31
ED10 Finisher jam Skew adjustment motor (M1) home position
detection abnormality: The Skew adjustment motor
is not at the home position. [MJ-1101 (when MJ-
6101 is installed)]
P. 6-50
ED11 Sideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
P. 6-50
ED12 Shutter home position error: The shutter is not at
the home position. [MJ-1101]
P. 6-50
ED13 Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
P. 6-50
ED14 Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
P. 6-50
ED15 Paddle home position error: The paddle is not at the
home position. [MJ-1101]
P. 6-51
ED16 Finisher jam
(Finisher section)
Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
P. 6-51
Error code Classification Contents Troubleshooting
To Next Page
Loading...
Need help?
General
