Installing Tracer Summit using Windows 98
BMTW-SVN01F-EN 183
2. Insert the Tracer Summit for Windows CD in the CD-ROM drive of
your PC. Tracer Summit automatically displays the Tracer Summit
Installation screen (see Figure 85).
Figure 85. Tracer Summit Installation Screen
3. Click Tracer Summit Setup Program button.
4. Follow the online instructions to install the application. The installa-
tion process takes 5 to 10 minutes, depending on the speed of the PC
and the amount of available memory.
Setting UP Network Adapters
Use the following instructions to set up network adapters for either
Ethernet or ARCNET.
To set up an Ethernet adapter using plug and play installation:
Follow the manufacturer’s plug and play instructions for an Ethernet
LAN adapter. When installation is complete, install the network adapter
protocol, and then verify the adapter status.
To install a PCI, PCMCIA, or ISA ARCNET card:
1. Install the ARCNET card:
• For PCI ARCNET cards, shut down the PC Workstation and
install the PCI ARCNET card in an available PCI slot. Insert the
Tracer Summit software CD in the CD-ROM drive of your com-
puter. Then, restart the computer. Follow steps 2–4.
• For PCMCIA ARCNET cards, the drivers are installed when you
do a custom setup of Tracer Summit (see “Custom Setup” on
page 186). Remove all cards from the laptop sockets prior to the
final step for installing Tracer Summit software.
• For ISA ARCNET cards, the drivers are installed when you do a
custom setup of Tracer Summit (see “Custom Setup” on
page 186).
2. Windows 98 Plug and Play software will detect the card and initiate
the new hardware installation wizard.