EasyManua.ls Logo

Uconnect 730N - Voice Command Operation

Uconnect 730N
232 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Voice Command Operation
Voice Command allows you to control your AM and FM
radio, satellite radio, disc player, navigation system, hard
disk drive storage, AUX mode devices (digital music
players) and a memo recorder.
NOTE:
Take care to speak into the Voice Command system as
calmly and normally as possible. The ability of Voice
Command to recognize user voice commands may be nega-
tively affected by rapid speaking or a raised voice level.
WARNING!
Any voice commanded system should be used only in
safe driving conditions following all applicable laws,
including laws regarding phone use. Your attention
should be focused on safely operating the vehicle.
Failure to do so may result in a collision causing serious
injury or death.
When you press the Voice Command
hard-
key, you will hear a beep. The beep is your
signal to give a command.
NOTE:
If you do not say a command within a few seconds, the
system will present you with a list of options.
If you ever wish to interrupt the system while it lists
options, press the Voice Command
hard-key, listen for
the beep, and say your command.
Pressing the Voice Command
hard-key while the
system is speaking is known as “barging in.” The system
will be interrupted and you can add or change com-
mands. This will become helpful once you start to learn
the options.
NOTE:
At any time you can say the words CANCEL, REPEAT,
HELP, or MAIN MENU.
118 VOICE COMMAND

Table of Contents

Other manuals for Uconnect 730N

Related product manuals