Enhanced phone functions 87
Held call wait status
After placing a call on hold, you can replace the handset and then decide wheth-
er to retrieve the call or disconnect.
Prerequisite: You placed a call on hold and replaced the handset or pressed
the loudspeaker key in speakerphone mode.
A recall follows immediately and a pop-up menu appears on the display:
Select and confirm the option shown to resume the call in speakerphone mode.
or
Select and confirm the option shown to disconnect the call.
Activating/deactivating the hold reminder tone
z
You can also configure this setting via the WBM interface ïƒ Page 206.
N Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec.j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown in the context menu.
Select and confirm the option shown.
If you enabled "Hold and hang-up" (ïƒ Page 89), the call is placed on hold
for a defined time interval (ïƒ Page 88) before the prompt is displayed with
a recall to retrieve the call or disconnect. You can however retrieve the
call or disconnect via the context menu before the defined time expires.
This function cannot be used on multi-line phones.
To Next Page
Loading...
Need help?
General