When all wheels slip, the real driving speed can only be measured with the radar
under the cab (optional equipment).
WARNING: Do not go under the tractor until the ignition key has been
turned to the
(OFF) position. If the tractor is equipped with a radar
(optional) it presents a hazard to your eyes.
3.13.14.1 Using the slip control
You can use the slip control when the draft control selector is in the draft control
area.
GUID-DE8EE63D-EDBC-4228-A2EF-EE79580E84CB
1. Draft control selector
2. Drive balance control selector
3. Drive balance control and slip control position
4. Slip control position
5. Drive balance control light
6. Slip control light
• Turn the drive balance control selector to the drive balance control and slip
control position.
Both the drive balance control and slip control are activated.
The slip control is activated when the lift/stop/lower switch is in the lower
position and the draft control selector is in the draft control area (position
1-8).
The slip control light is lit when the slip control is activated and driving speed
is more than 1 km/h.
• Turn the drive balance control selector to the slip control position.
Only the slip control is activated.
The slip control light is lit when the slip control is activated and driving speed
is more than 1 km/h.
3. Operation
- 219 -
To Next Page
Loading...
