distances between the functions are stored in the tractor memory. After this, the
programme can be started with one press of a button.
The actual driving speed can differ from the driving speed used during recording
the U-Pilot, but the distances between the different functions are kept the same.
The U-Pilot has two memory slots. For example, you can use the memory slots to
use separate programmes for coming to headland and leaving the headland.
You can save 30 programmes which can be used in both memory slots. You can
also edit the saved programmes.
DANGER: When using the U-Pilot, the functions of a programme start
automatically. Ensure that nobody is in the hazard area.
CAUTION: The switches do not show the equipment status when
using the U-Pilot.
3.20.1 U-Pilot operating requirements
For the U-Pilot to work properly, certain requirements have to be met.
• The driving speed must be 0.5-20 km/h (tractor must move even if the
distance unit is time).
• The maximum amount of operations for one programme is 30.
• The maximum distance for an operation cycle is 100 m without a pause.
• The maximum distance between the starts of two consecutive functions is
63.5 m.
• The distance is measured with the accuracy of 0.5 m. The minimum distance
between different functions is 0.5 m even if the function switches were
pressed within a shorter distance.
• The maximum length of a pause is 5 minutes.
• The maximum amount of programmes is 30.
3.20.2 U-Pilot controls
GUID-FC110209-ECC5-49C0-B1B4-65D4B03FBCC2
3. Operation
- 280 -
To Next Page
Loading...
