Maintenance check point 10 h 50 h 600 h 1200 h 2400 h
Check the engine oil level. ● ● ● ● ●
Check the coolant level. ● ● ● ● ●
Check and clean the radiator fins and engine cover grilles. ● ● ● ● ●
Check the oil level in the transmission and hydraulic system. ● ● ● ● ●
Check for oil and fuel leaks. ● ● ● ● ●
Grease the rear linkage. ● ● ● ●
Check and grease the pick-up hitch. ● ● ● ●
Check and grease the front linkage. ● ● ● ●
Check the front power take-off. ● ● ● ●
Grease the brake mechanism. ● ● ● ●
Grease the front axle mounting bearings. ● ● ● ●
Check the belts' tension. ● ● ● ●
Check the tyre pressure. ● ● ● ●
Check the emergency brake. ● ● ● ●
Check the windscreen washer fluid level. ● ● ● ●
Check the air pressure system antifreeze fluid level. ● ● ● ●
Check, clean and grease the battery terminals. ● ● ●
Change the engine oil and filter.
●
1)
● ●
Change the cab ventilation air filter.
●
2)
● ●
Change the recirculation air filter. ● ● ●
Check the front loader frame bolt tightness.
●
3)
● ●
Check the wheel nut tightness. ● ● ●
Check the brake pedal free travel. ● ● ●
Check the parking brake. ● ● ●
Change the oil filters of the transmission and hydraulic system. ● ● ●
Check the engine breathing system. ● ● ●
Check the oil level in the front axle differential and hubs. ● ● ●
Change the front power take-off oil and wash the oil filter. ● ● ●
Check the front power take-off couplings. ● ● ●
Grease the rubber surfaces of the trailer quick couplings. ● ● ●
Check the integrity of the air pressure system. ● ● ●
Check the air pressure system automatic water draining. ● ● ●
Fill the air pressure system antifreeze container. ● ● ●
Update the software and calibrate the tractor.
●
4)
● ●
Adjust the engine valves.
●
5)
●
Change the oil in the hydraulic system. ● ●
Change the oil in the front axle differential and hubs. ● ●
Change the fuel filter and prefilter.
●
6) 7)
●
Change the engine air filters.
●
8)
●
Change the selective catalytic reduction system breather and
supply module main filter.
●
9)
●
Check the front wheel toe-in. ● ●
Change the hydraulic breather. ● ●
Check the power shuttle operation. ● ●
Table continued on next page
4. Maintenance
- 344 -
To Next Page
Loading...
