Vermeer Navigator D20x22 II Series User Manual

D20x22 Series II Navigator HDD Overview 30-59
AutoDrill - Resume
If the engine has not been shut off since the AutoDrill feature has been
turned on, then AutoDrill may be RESUMED after PAUSING by holding the
AutoDrill Resume Button (1) for 1.5 seconds. AutoDrill will resume to the last
stored thrust/pullback and rotation set points. Rotation will operate for 2–3
seconds before thrust or pullback starts.
If thrust or rotation has not been active for 5 minutes, the AutoDrill mode
will need to be reset.
Restarting the AutoDrill function by using the Resume command is only
possible if the Front Vise Switch (2) is in the RELEASED position. If the front
vise is clamped and the operator tries to resume, the AutoDrill function will
not work and the display will flash “VISE” until the operator moves the Front
Vise Switch to the RELEASED position. When front vise is released, the AutoDrill function can be restarted by
pressing the Resume Button (1) for 1.5 seconds.
AutoDrill - Disable
AutoDrill set points are cleared by shutting off the engine.
It is also disabled if both Thrust/Pullback and Rotation Handles have been placed in
NEUTRAL for more than 5 minutes after pausing in AutoDrill. AutoDrill Light (1)
will turn off.
1
2
1

Vermeer Navigator D20x22 II Series Specifications

General

Brand	Vermeer
Model	Navigator D20x22 II Series
Category	Construction Equipment
Language	English