Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
105
2.33 Differential Ring
Description
Differential Ring allows any one of 14 different audible Ring signals to be assigned to iPECS IP
and 15 Ring signals for the LDP Phones, allowing you to determine which phone is ringing and
the type of call (Intercom or external). When the phone receives an incoming call, the selected
ring signal is provided over the speaker. Different selections are assigned for Intercom and
outside calls.
Eight different tones are stored in the iPECS IP Phones. Four of these tones are permanent while
the other four are downloaded from the 10 ring-tones in the iPECS system.
In addition, each outside Line can be configured to provide one of twelve different ring tones so
that you can determine which outside Line is ringing.
Operation
iPECS IP Phones
To select the desired ring tone
1. Press the [TRANS/PGM] button.
2. Dial ―1‖ for Ring Selection.
3. Dial ―1‖ for Intercom or ―2‖ for outside Line ring
4. Dial Ring Tone selection ―1‖-―8‖, the ring tone is received.
To download a Ring tone from the system to an iPECS IP Phone
1. Press the [TRANS/PGM] button.
2. Dial 1 for Ring selection.
3. Dial 5 for Ring tone download.
4. Dial the Ring tone storage bin ―5‖-―8‖.
5. Dial the Ring tone selection, ―0‖-―9‖, the tone is received.
6. Press the [HOLD/SAVE] button.
LDP Phones
To select the desired ring tone
1. Press the [TRANS/PGM] button.
2. Dial ―1‖ for Ring Selection.
3. Dial ―1‖ for Intercom or ―2‖ for outside Line ring
4. Dial Ring Tone selection ―1‖-―15‖, the ring tone is received.
To Next Page
Loading...
