Vertical Summit80 - Net Intercom Call

Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
237
Conditions
1. To use the networking features, the software lock-key installation is required. To obtain
a lock-key, contact your local Ericsson-LG Enterprise representative with the system
serial number.
2. Each station must have a unique station number of up to eight (8) digits, which is
based on their local system Station Numbering Plan.
3. The Network Numbering Plan permits 251 entries, allowing up to 251 iPECS systems
to be in a single distributed network environment.
4. The alternative route employs a Speed Dial number to place a call and is not a
Networked call. Thus, the Distributed Control Network features do not apply.
Programming
Keyset Admin.
SYSTEM
Networking Basic Attribute (PGM 320)
Networking CO Line Attribute (PGM 322)
Network Numbering Plan Table (PGM 324)
Network Feature Code Table (PGM 325)
Web Admin.
NETWORKING DATA
Network Basic Attributes
Network Supplementary Attributes
Network CO Line Attributes
Network Numbering Plan
Network Feature Code Table
Related Features
Hardware
2.79.2.1 Net Intercom Call
Description
You can place calls to stations connected to other networked systems. Station calls across the
network are always terminated in the Tone Ring Intercom Signaling mode. Station calls are
placed in the normal manner by dialing the desired station number or pressing a {Net-DSS}
button.
Operation
iPECS IP & LDP Phones
To assign a Flex button as a {NET DSS} button:
[TRANS/PGM] + {FLEX} + Station Number + [HOLD/SAVE]