Vertical Summit80 - In-Room Indication

Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
139
2.46 In-Room Indication
Description
As an In-Room Supervisor, you can notify other station users that you are in the room and the
phone is idle using a Flexible button on your phone. Activating the In-Room indicator illuminates
the LED of the In-Room Indicator button assigned to the other stations. This feature is often used
in small call centers or where the Supervisor‘s office is not visible by the supervised employees.
Up to ten (10) In-Room Supervisors can be assigned with up to twenty notified stations for each
Supervisor.
You may assign a Flex button for In-Room indication however; the In-Room Supervisor can only
be assigned in the system database.
Operation
iPECS IP & LDP Phones
To assign an “In-Room Indication button”
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + ―9*‖ + In-Rom Bin No (01~10) + [HOLD/SAVE]
To Active or Deactivate the In-Room Indication from the Supervisor phone while idle,
1. Press the In-Room button.
2. Press the [HOLD/SAVE] button.
Conditions
1. The In-Room Indication button operates only while the Supervisor‘s phone is idle.
2. If the In-Room button on a station other than the Supervisor‘s is pressed, error tone is
heard.
3. The Supervisor must press the [HOLD/SAVE] button within 5 seconds of pressing the
In-Room button to activate the indication otherwise; the station goes back to the idle
state.
Programming
Keyset Admin.
SYSTEM
In-Room Indication (PGM 183)
Web Admin.
SYSTEM DATA
In-Room Indication
Related Features
Hardware