Vertical Summit80 - Station User Programming & Codes

Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
378
5.25 Station User Programming & Codes
Description
You can program an array of functions and features, access status information and assign special
features codes to Flex buttons of your iPECS IP or LDP Phone. The Station User Program Codes
used for these purposes are fixed as listed below.
Code
Description
Entries
10
Enblock Dial
11x
Intercom Differential Ring
1~8 (Level may be different)
12x
Outside Line Differential Ring
1~8 (Level may be different)
13
Station Answer Mode
1: H, 2: T, 3: P
14x
Call Coverage Attribute
1~2
15x
Station Ring Download
5~ 8 + 0~9
19
Ear Mic. Headset
21
Knock down Station COS (Class of Service)
22
Restore Station COS (Class of Service)
Auth code
23
Walking COS (Class of Service)
Auth code
24
ICR Scenario
Scenario Data
25
LIP Phone Statistics
Real-time Packet Monitoring
26
Call profile Table Index
0-3
31
Station Message Wait Retrieve
32
CLI/IP Message Wait Retrieve
33
Register Authorization Code
Auth Code
34
DID/DISA Call Wait
35
Choice Exec/Sec Message
1 On, 0 Off
36
SMS sending mode
37
Register Mobile Extension
Tel. number
38
Activate Mobile Extension
1 On, 0 Off
39
Register Mobile Ext CLI
Tel. number
30
VM Mobile notify
1 On, 0 Off
41
Set Wake-Up Time
Once/Permanent & Hour/Min
42
Erase Wake-Up Time
51
Custom/Pre-selected Message
00~20
52
Register Custom Message (00)
―Message‖
53
Create Conference Room
Room number (1~9)