Vertical Summit80 - System Speed Dial

Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
212
2.73.4 System Speed Dial
Description
Commonly dialed numbers can be stored by the System Attendant or by the Administrator in Web
Admin for easy access by stations allowed use of System Speed Dial bins. With Summit80, up to
3000 System Speed Dial numbers are available and with Summit800, up to 8000 System speed
dial numbers are available. Each Speed Dial number can be up to 23 characters in length and
may include special instruction codes.
Special instruction codes available are:
‗*‘ as 1st digit
Activate Display Security.
Flash as 1st digit
Activate dial tone detect.
[DND]
Insert a Flash command.
‗*‘ not 1st digit
Switch from Pulse to DTMF dialing.
[MESSAGE/CALLBACK]
Insert a pause dialing command.
You may assign a Flex button of your iPECS IP or LDP Phone for One-Touch access to a
specific System Speed Dial bin.
Operation
iPECS IP & LDP Phones
To assign a Flex button as a {SYSTEM SPEED DIAL} button
[TRANS/PGM] + {FLEX} + [SPEED] + System Speed Dial bin number + [HOLD/SAVE]
To dial using a System Speed Dial using a [SPEED] button
1. Lift handset or press the [SPEAKER] button.
2. Press the [SPEED] button.
3. Dial the desired bin number (Summit80:2000-4999 / Summit800: 2000-9999)
To dial a System Speed Dial number using an LIP-8000/LIP-9000 series phone with soft
buttons
1. Press the [DIR] soft button.
2. Press the [SPEED] soft button.
3. Dial the desired bin number (Summit80:2000-4999 / Summit800: 2000-9999)
SLT
To dial using a System Speed Dial
1. Lift handset.
2. Dial ―558‖, the SLT Speed Dial access code.