Vertical Summit80 - DID Line Digit Conversion

Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
317
4.8 DID Line Digit Conversion
Description
When you place an outside call the digits you dial are compared with the Digit Conversion Table.
If a match is found, the digits are converted as defined in the table. Within the table are 15 sub-
tables with up to 200 entries of up to sixteen digits for each sub-table for Summit80. With
Summit800, within the table are 32 sub-tables with up to 200 entries of up to sixteen digits for
each sub-table.
Different conversion can be assigned for the same dialed number based on the system service
mode and LCR configuration. Conversion can also be limited to outside calls from a station or an
outside Line. The latter may be used in networked environments where a system in the network
employs Lines from another system to place a call.
Operation
Digit Conversion is applied automatically according to programming.
Conditions
1. Each CO line can have a Digit Conversion Tables.
2. There are two (2) special entries for configuring digit conversion:
− X: Mask Digit, any digit is accepted
− F: Ignore Digit
Programming
Keyset Admin.
SYSTEM
Digit conversion Table (PGM 270)
Web Admin.
Station DATA
Common Attribute  Digit Conversion Table Index
Table DATA
Digit conversion Table
Related Features
Hardware