Vertical Summit80 - Page 94

Vertical Summit80 & Summit800
Feature Description and Operation Manual Issue 1.2
83
Operation
iPECS IP & LDP Phones
To set up an Unsupervised conference
1. Establish a conference with external parties as normal.
2. Press the [CONF] button. The [CONF] button LED flashes to indicate the Unsupervised
Conference state.
To reenter the Unsupervised conference
1. Press the flashing [CONF] button.
Conference Party
To extend the Unsupervised Conference from a connected party
1. Dial ―# #‖.
2. Dial the Timer extension multiplier (1~9).
Conditions
1. The Unsupervised Conference Timer also applies to an external call placed by to a
DISA line in the system.
2. An Unsupervised Conference will be terminated if the system receives a disconnect
signal or the Unsupervised Conference Timer expires.
3. An Unsupervised Conference will not recall the user.
Programming
Keyset Admin.
NUMBERING
Unsupervised Conference Timer Extension (PGM 109-Button3)
STATION
Off Net Forward (PGM 111-Button 14)
SYSTEM
CO to CO UC Time Extension (PGM 160-Button 12)
Unsupervised Conference Timer (PGM 182-Button 5)
Web Admin.
SYSTEM ID
&NUMBERING PLANS
Flexible Numbering Plan Unsupervised Conference Timer
Extension Code
STATION DATA
Common Attributes Off-Net Forward
SYSTEM DATA
System Attributes  CO to CO Unsupervised Conference
Time Extension
System Timers Unsupervised Conference Timer
Related Features
 Direct Inward System Access (DISA)
 Multi-Party Voice Conference
Hardware
 iPECS IP or LDP Phone