• Log out of the web UIby clicking the Log Out button in the top right corner.
• View the number of events in the console and in the U-level from the past three days and the number of
IPMIdevice alarms by clicking the ITEvents/Alarms icon.
• View the critical, moderate, and low alarms by clicking the appropriate icon.
• Configure the alarm sound by clicking the Mute link to set the new alarm tone to Open. When an alarm is
generated, a sound will play.
9.2.1 Facility overview
The Facility Overview page contains information related to site/room floor plans, average aisle temperature, real-time power,
and energy management.
Overview
From the Overview section, you can modify the device hotspot and background settings. Refer to the following procedures for
more information.
Device hotspots
Note the following about device hotspots:
• The upper limit of new hotspots is 128.
• The upper limit of the number of hotspot types is 30. To upload the hotspot type icon, the image with the
following suffix is supported: .svg, .png, .jpg, .jpeg, .bmp, .ico. The icon file size should not exceed 500KB.
• Each hotspot can be bound to no more than 16 signals. The hotspot needs to be bound to at least one signal
before it can be saved to the backend.
• After modifying the hotspot information, click the SAVE button to implement your changes. Otherwise, the
configuration information will be lost.
To add a new device hotspot:
1. Click the enter setup mode icon in the right-hand side of the Overview section to enter the setting state.
2. Click on the plus (+) icon to add a new device hotspot.
3. Left-click the mouse and drag the hotspot to the desired location.
4. Click on the hotspot to view, edit, or delete the hotspot.
5. Click Edit. The Device Signal Setting window appears.
6. Click Add. A new row is added to the table.
7. Enter the appropriate device and signal name for the hotspot by using the respective drop-down menu.
8. Click on the checkmark icon on the right-hand side of the row to complete the addition of the new row.
9. When finished, click Confirm and save your changes. The hotspot displays on the background image of the
screen.
To delete a hotspot:
1. Click the enter setup mode icon in the right-hand side of the Overview section to enter the setting state.
2. Click on the hotspot you wish to delete.
3. Click Delete. A confirmation box for deleting the hotspot appears.
4. Click the Confirm button.
5. Click Save.
96 Proprietary and Confidential ©2024 Vertiv Group Corp.
9 Vertiv™ Liebert® RDU501
Intelligent Monitoring Unit Web User
Interface (UI)
Vertiv™ SmartRow™ 2 Infrastructure Solution User Guide
To Next Page